EVIC home page
The EVIC-111 Mk7A Electronics Package
A fully assembled and tested electronics package consisting of:
The EVIC Mk7A Control Board with
· Programmed PIC16F628A and 4 PIC12F6xx micros for more precise control
· Control of intake and exhaust valve solenoids
· Normal operation and "Electronic Throttle" operation
· 2 speed Hit and Miss operation
· Automatic spark advance with speed
· High performance IGBT coil ignition circuit
· Can be used to trigger a CDI module
· Multiple sparks at low speeds
· Constant ignition dwell time extends ignition battery life
· Ignition automatically turned off if engine stalls or is not running
· Micro sockets allow you to experiment or install future software upgrades
· Connectors for the Hall Effect Sensor Boards
· Terminal Blocks for connections to your Solenoids, Coil and Power supply
· LED indicator for the Ignition Dwell
· 1 150KHz high efficiency DC-DC Converter
· Runs from your 36 volt battery or power supply
Hall Effect Sensor Board with cable and connector
· LED indicator for easy setting of the engine timing
Linear Hall Effect Valve Position Sensor Boards with cable and connector
· Provides true analog valve position sensing for improved valve control
E-mail me with your requirements for current price.
David C. Bowes
1095 Afton Road
Peterborough, Ontario, Canada
K9J 8L1
Phone: 705-745-1088 - - - E-Mail: dbowes12@cogeco.ca
The Optional EVIC "ET" Controller
Standard version shown.
Now supplied with
two push button switches.
· Standard version now supplied with Up/Down Push Button switches
· 8 LED indicators for the "Electronic Throttle" position
· With connector to connect to the main control board
· R/C version available with a Futaba J connector that plugs directly into your R/C receiver
E-mail me for current prices.
David C. Bowes
1095 Afton Road
Peterborough, Ontario, Canada
K9J 8L1
Phone: 705-745-1088 - - - E-Mail: dbowes12@cogeco.ca
Updated, February 11, 2011